—— Products Center ——

Factory wholesale Road Painting Equipment - Thermoplastic Road Making Paint – Luxinda

Update time:Jan-08-2016

Short Description:


3 Levels of Thermo to ft your budget

Specification of this Thermoplastic Road Making Paint Manufacturer


Test item Technical requirements Test value Conclusion
Density(g/cm³) 1.8~2.3 1.99 Qualified
softening point 90~125 104 Qualified
drying time ≤3 3 Qualified
film appearance

No wrinkle,spot,blister,crack,off,Glued tyres

,the colour of fill appearance should be closed to standard

Meet the requirement Qualified
colorimetric Characteristics luminance factor(white) ≥0.75 Meet the requirement Qualified
luminance factor(yellow) ≥0.45 Meet the requirement Qualified
Compression strength   ≥12 23.8 Qualified
water resistence There's no abnormal phenomena 24 hours after being Soaked in the water Meet the requirement Qualified
alkali resistance

There's no abnormal phenomena 24 hours after being

 Soaked in the Saturated calcium chloride solution

Meet the requirement Qualified
Glass bead content 18~25 22.9 Qualified
The coating crack resistance at low temperature

Keep 4h in ten degrees below zero

,then keep 4h in indoor temperature. 

After repeating three times, there’s no crack

Meet the requirement Qualified
 thermal stability

Keep 4h in between 200℃ to 220℃ when stiring

,there's no obvious phenomenon of yellowing,coking,caking etc.

Meet the requirement Qualified

Pictures of this China Thermoplastic Road Making Paint


Our Pictures of this Thermoplastic Road Making Paint Factory 

Looking forward to your inquiry for this Thermoplastic Road Making Paint Manufacturer